Dometic PERFECTVIEW M7LS Instructions De Montage Et De Service page 19

M7LS
To perform the installation, proceed as follows (fig. e, page 9):
➤ Slide the monitor (1) onto the mounting plate of the monitor bracket (2) and secure it on the
monitor bracket with the knurled screw (3).
➤ Position the monitor and the attached monitor bracket for testing.
➤ Mark the outlines of the corners of the monitor bracket (2) on the dashboard.
➤ Unscrew the monitor from the monitor holder.
➤ Hold the monitor bracket within the outlines marked beforehand and mark four different drill-
ing points.
➤ Drill Ø 2 mm holes at the points you have just marked.
➤ Screw on the monitor bracket with the 4 x 20 mm self-tapping screws.
➤ Slide the monitor (1) onto the mounting plate of the monitor bracket (2) and secure it on the
monitor bracket with the knurled screw (3).
I
NOTE
You can now adjust the angle of inclination. To do this, loosen the knurled screw (4)
and tilt the monitor to the desired position. Tighten the knurled screw (4).
7.3 Laying the system cable from the camera to the monitor
I
NOTE
Lay the camera cable so that should you need to remove the camera, you can access
the plug connection between the camera and the extension cable easily. This greatly
facilitates the disassembly.
➤ Lay the system cable for the camera inside the vehicle.
➤ Lay the system cable for the camera to the monitor.
➤ Connect the monitor connection cable to the system cable.
➤ Insulate the plug connection with the insulating tape supplied. Overlap every layer of the insu-
lating tape by one half of its width.
➤ Attach the cables securely in the vehicles to prevent tripping hazards. This can be performed
by using cable binders, insulating tape or gluing in place with adhesives.
I
NOTE
Only start sealing through-holes when you have completed all installation work on the
camera and have laid the required cable lengths.
EN
Mounting the monitor
19