Using The Lcd Monitor - Dometic WAECO PerfectView M5L Instructions De Montage Et De Service

All manuals and user guides at all-guides.com
_M5L_M7L_M7LX.book Seite 33 Donnerstag, 14. Januar 2010 3:03 15
PerfectView M5L, M7L, M7LX
This control cable is used as a signal cable for the activation e. g. of a side camera
when an indicator is flashing.
If necessary, connect the socket C1 (9) of the connection cable to the plug of the
video source 1 (e. g. camera).
If necessary, connect the socket C2 (10) of the connection cable to the plug of
the video source 2 (e. g. side camera).
M7LX only: If necessary, connect the socket C3 (11) of the connection cable to
the plug of the video source 3 (e. g. reversing camera).
NOTE
I
Observe the power consumption of the video system. The cameras are
equipped with heaters. A maximum current of 1.5 A can flow (three
cameras in heating mode). Use a disconnector switch for direct connection
to the battery. This allows you to disconnect the video system from the
battery easily if you are no longer using the vehicle.
Connecting an additional reversing camera (trailer operation)
M5L, M7L: If necessary, connect socket C3 (11) of the connection cable to the
plug of the additional reversing camera.
M7LX: If necessary, connect socket C4 (12) of the connection cable to the plug
of the additional reversing camera.
8

Using the LCD monitor

8.1 Switching on the monitor
If the monitor is switched off, press the "P" button (fig. 0 6, page 5) to switch
the monitor on.
The picture appears.
8.2 Switching off the monitor
Press the "P" (fig. 0 6, page 5) button to switch off the monitor.
The picture disappears.
8.3 Adjusting the monitor (fig. 0, page 5)
To set the monitor to suit your requirements, proceed as follows:
Press the "MENU" button (3) to call up the required parameter.
The parameters to be set appear in the following order:
Page 1:
– Brightness: 0 – 60
– Contrast: 0 – 60
– Colour: 0 – 60
Using the LCD monitor
33