Cleaning And Caring For The Lcd Monitor - Dometic WAECO PerfectView M5L Instructions De Montage Et De Service

All manuals and user guides at all-guides.com
_M5L_M7L_M7LX.book Seite 35 Donnerstag, 14. Januar 2010 3:03 15
PerfectView M5L, M7L, M7LX
8.5 Using the monitor with two reversing cameras
(trailer operation) (fig. c, page 6)
You do not need to make any settings to the monitor during operation. The monitor
automatically detects whether one or two cameras are connected (e.g. to a truck-
trailer combination).
One camera connected (e. g. tractor or trailer): the camera connected to C1 (1)
is activated.
Two cameras connected (e. g. tractor with trailer):
– M5L, M7L only: the camera connected to C3 (2) is activated.
(C1 is inactive).
– M7LX only: the camera connected to C4 (2) is activated.
(C1 is inactive).
8.6 Setting distance markers (M7LX) (fig. 0, page 5)
To set the distance markers, proceed as follows:
Press the "MENU" button (3) to call up the required parameter.
The parameters to be set appear.
Press the "MENU" button (3) again to select the parameter "Set distance
markers".
Press the "–" button (4) to display the distance markers.
Press the "–" button (4) again to select the parts to be set.
The parts to be set are highlighted in red.
Press the "+" button (5) to set the part highlighted in red.
You can slide each distance marker to one of three positions.
The first time you press, the side marker will be activated, the second time the
upper distance marker, the third time the middle, the fourth time the lower, etc.
Press the "MENU" button (3) to exit the settings.
9

Cleaning and caring for the LCD monitor

NOTICE! Risk of damage
A
Do not use sharp or hard objects for cleaning as these may damage the
monitor.
Remove the cable before cleaning the monitor to prevent short circuiting.
Clean the monitor with a soft, damp cloth from time to time.
Cleaning and caring for the LCD monitor
35