Table des Matières
Publicité
system complies with the requirements of the system
standard IEC60601-1-1.
If in doubt, consult the qualified service personnel.
3. The leakage current could increase when connected to
other equipment.
4. For this particular equipment, all accessory equipment
connected as noted above, must be connected to mains
via an additional isolation transformer conforming with
the construction requirements of IEC60601-1 and
providing at least Basic Insulation.
5. This equipment generates, uses, and can radiate radio
frequency energy. If it is not installed and used in
accordance with the instruction manual, it may cause
interference to other equipment. If this unit causes
interference (which can be determined by unplugging
the power cord from the unit), try these measures:
Relocate the unit with respect to the susceptible
equipment. Plug this unit and the susceptible
equipment into different branch circuit.
Important EMC notices for use in the medical environments
• The AC-110MD needs special precautions regarding
EMC and needs to be installed and put into service
according to the EMC information provided in this
instructions for use.
• The portable and mobile RF communications equipment
such as cellular phones can affect the AC-110MD.
Warning
The use of accessories and cables other than those
specified, with the exception of replacement parts sold by
Sony Corporation, may result in increased emissions or
decreased immunity of the AC-110MD.
The AC-110MD is intended for use in the electromagnetic environment specified below.
The customer or the user of the AC-110MD should assure that it is used in such an environment.
Emission test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Warning
If the AC-110MD should be used adjacent to or stacked
with other equipment, it should be observed to verify
normal operation in the configuration in which it will be
used.
8
Guidance and manufacturer's declaration-electromagnetic emissions
Compliance
Group 1
Class B
Class D
Complies
Consult your dealer. (According to standard EN60601-1-2
and CISPR11, Class B, Group 1)
For the customers in Sweden (För
kunderna i Sverige)
Apparaten skall anslutas till jordat uttag
For the customers in Finland (Suomessa
asuville asiakkaille)
Laite on liitettävä suojamaadoituskoskettimilla
varustettuun pistorasiaan
For the customers in Norway (For kundene
i Norge)
Dette utstyret kan kobles til et IT-strømfordelingssystem.
Apparatet må tilkoples jordet stikkontakt
Electromagnetic environment-guidance
The AC-110MD uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
The AC-110MD is suitable for use in all establishments,
including domestic establishments and those directly connected
to the public low-voltage power supply network that supplies
buildings used for domestic purposes.
Publicité
Table des Matières
