Lock Screen; Swap Pan And Tilt; Pan/Tilt Speed; Wdmx Reset - Chauvet Professional Maverick MK2 Profile Manuel D'utilisation

Lock screen

To completely lock or unlock the control panel, follow the instructions below:
1. Navigate to the Settings
2. Use <UP> or <DOWN> to select Lock Screen, or touch the display where it says Lock Screen.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (display will respond to touch or
buttons) or YES (display will not respond to touch or buttons), or touch the display where it says
the desired option.
5. Press <ENTER>.
To unlock the touchscreen and menu buttons, do the following:
1. Touch the display touchscreen anywhere or push any menu button.
2. Enter the passcode 0920 using the touchscreen or buttons.
3. Press <ENTER>.

Swap pan and tilt

To switch the pan and tilt functions so that what normally controls the pan controls the tilt and what
normally controls the tilt controls the pan, do the following:
1. Navigate to the Settings
2. Use <UP> or <DOWN> to select Swap XY, or touch the display where it says Swap XY.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (normal pan and tilt) or YES (pan
controls tilt, tilt controls pan), or touch the display where it says the desired option.
5. Press <ENTER>.

Pan/tilt speed

To set the maximum speed of the pan and tilt:
1. Navigate to the Settings
2. Use <UP> or <DOWN> to select XY Mode, or touch the display where it says XY Mode.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Slow or Fast, or touch the display where it
says the desired option.
5. Press <ENTER>.

WDMX reset

To reset the WDMX connection from the Maverick MK2 Profile, do the following:
1. Navigate to the Settings
2. Use <UP> or <DOWN> to select WDMX Reset, or touch the display where it says WDMX Reset.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (do not reset connection) or YES (reset
the connection), or touch the display where it says the desired option.
5. Press <ENTER>.
Once a WDMX receiver has been linked to a specific WDMX transmitter, it will
remain linked to that specific transmitter until it is linked to a different one.

Backlight timer

To set the amount of time after inactivity before the display backlight turns off:
1. Navigate to the Settings
2. Use <UP> or <DOWN> to select Backlight Timer, or touch the display where it says
Backlight Timer.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select 30S (after 30 seconds of inactivity),
1M (after 1 minute of inactivity), 5M (after 5 minutes of inactivity), or ON (does not turn off),
or touch the display where it says the desired option.
5. Press <ENTER>.
Page 19 of 209
menu.
menu.
menu.
menu.
menu.
Maverick MK2 Profile User Manual Rev. 3
Operation