Operating Settings Configuration; Home Screen; Start Address; Network Setup - Chauvet Professional Maverick MK2 Profile Manuel D'utilisation

Operating Settings Configuration

Home Screen

The Maverick MK2 Profile has a home screen that shows the protocol mode, the IP address or DMX
address, the DMX personality, and the current product temperature. To see the home screen, press
<MENU> repeatedly until it shows on the display. On the Home Screen, press one of the menu buttons to
immediately access any part of the menu (e.g., Personality, Starting Address, or Universe) or press the
<ENTER> button to access the main menu.

Start Address

To set the starting address, set the
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Start Address, or touch the display where it
says Start Address.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Enter the starting address (001–512) with one of the following methods:
• Type the address number using the number pad that shows on the touchscreen display.
• Using the buttons (or the button icons on the sides of the display):
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
5. Press <ENTER>.

Network Setup

The universe of the TCP/IP protocol will be the universe of the DMX function.

IP mode

The IP address of the Maverick MK2 Profile can be set manually, by the network, or to a preset static
address specific to each product. To set the IP Mode, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Network Setup, or touch the display where
it says Network Setup.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select IP Mode, or touch the display where it says IP Mode.
5. If using the buttons instead of the touchscreen, press <ENTER>.
6. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from:
• Manual – set the IP address with the control panel
• DHCP – the network sets the IP address
• Static – a preset address specific to each product, or touch the display where it says the
desired mode
7. Press <ENTER>.

Universe

The Universe must be assigned through the product menu. To set the Universe, do the following:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Network Setup, or touch the display where
it says Network Setup.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select Universe, or touch the display where it says Universe.
5. If using the buttons instead of the touchscreen, press <ENTER>.
6. Enter the universe address (0–255) with one of the following methods:
• Type the universe number using the number pad that shows on the touchscreen display.
• Using the buttons (or the button icons on the sides of the display):
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the universe or subnet is set as desired.
7. Press <ENTER>.
Page 15 of 209
Control mode and then follow the instructions below:
Home Screen shows on the display. Press <ENTER>.
Home Screen shows on the display. Press <ENTER>.
Home Screen shows on the display. Press <ENTER>.
Maverick MK2 Profile User Manual Rev. 3
Operation