Bevel Cutting - Makita DHS782 Manuel D'instructions

Bevel cutting

CAUTION:
After adjusting the bevel angle,
always tighten the clamping screws securely.
Loosen the clamping screws. Set for the desired angle
by tilting accordingly, then tighten the clamping screws
securely.
► 1 . Clamping screw
Use the stopper when you do precise 45° angle cutting.
Fully turn the stopper as illustrated depending on 0° -
45° bevel cut or 0° - 48° bevel cut.
0° - 45°
0° - 48°
► 1 . Stopper
Sighting
For straight cuts, align the 0° position on the front of the
base with your cutting line. For 45° bevel cuts, align the
45° position with it.
► 1 . Cutting line (0° position) 2. Cutting line (45° position)
Lighting the lamp
1
CAUTION:
source of light directly.
To turn on the lamp without running the tool, pull the
switch trigger without pressing the lock-off button.
To turn on the lamp with the tool running, press and hold
the lock-off button and pull the switch trigger.
The lamp goes out 10 seconds after releasing the switch trigger.
1
► 1 . Lamp
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Hook
Optional accessory
CAUTION:
hanging the tool with the hook.
CAUTION:
tions or on the surfaces where the tool may lose
the balance and fall.
CAUTION:
when it is hooked.
10 ENGLISH
1
Do not look in the light or see the
1
Always remove the battery when
Never hook the tool at high loca-
Do not pull the tool downward
2