Fault Table; After Maintenance And Troubleshooting - RK Rose+Krieger RK MonoLine R Manuel D'utilisation

6.4 Fault table

Fault description
High noise production
Guide shafts are corroded
and dirty
Timing belt is overstretched Timing belt is overloaded,

6.5 After maintenance and troubleshooting

26.03.2019
Cause
Grooved ball bearing in the
pulley box is damaged
Rollers are damaged
Timing belt is worn
Insufficient lubrication
e.g. due to a blockage
Perform the following steps once maintenance and troubleshooting
are complete:
1. Check that all screw connections loosened previously are
secure.
2. Ensure that all tools, materials and other equipment used
have been removed from the work area.
3. Clean the work area and remove any escaped substances
such as liquids, processing material or similar products.
Linear unit RK MonoLine R/RK MonoLine Z
Maintenance and troubleshooting
After maintenance and troubleshooting
Remedy
Replace the grooved ball
bearing.
Replace rollers.
Replace the timing belt.
Contact RK Rose
+Krieger GmbH.
Contact RK Rose
+Krieger GmbH.
Personnel
Assembly staff
Assembly staff
Assembly staff
Assembly staff
Assembly staff
111