Final Check - Beko HISW 63222 SO Manuel D'utilisation

3 Installation
5. For the last control, bring the burner both to
high-flame and reduced positions and check
whether the flame is on or off.
6. Depending on the type of gas tap used in your
appli-ance the adjustment screw position may
vary.
1. Flow rate adjustment screw
WARNING: Making connections
A
to different holes is not a good prac-
tice in terms of safety since it can
damage the gas and electrical sys-
tem.
WARNING: There are gas and
electric components on hobs.
Therefore stove, only the connec-
A
tion hole shown in this manual
should only be fixed to the unit as
shown in the manual using the sup-
plied fasteners and screws supplied.
Otherwise, it is dangerous to the life
and property safety.
1. Flow rate adjustment screw
Built-In Hob / User Manual
If the gas type of the unit is changed,
C
then the rating plate that shows the
gas type of the unit must also be
changed.
3.8 Future Transportation
• Keep the product's original carton and transport
the product in it. Follow the instructions on the
carton. If you do not have the original carton,
pack the product in bubble wrap or thick card-
bo-ard and tape it securely.
• Secure the caps and pan supports with adhesive
tape.
• Check the general appearance of your product
for any damages that might have occurred dur-
ing transportation.

3.9 Final check

1. Open gas supply.
2. Check gas installations for secure fitting and
tightness.
3. Ignite burners and check appearance of the
flame.
Flame must be blue and have a reg-
C
ular shape. If the flame is yellowish,
check if the burner cap is seated se-
curely or clean the burner.
19 / EN