Gas Connection - Beko HISW 63222 SO Manuel D'utilisation

3 Installation
• Connection must comply with national regula-
tions.
• The mains supply data must correspond to the
data specified on the type label of the product.
Type label is at the rear housing of the product.
• Power cable of your product must comply with
the values in "Technical specifications" table.
Before starting any work on the
B
electrical installation, disconnect
the product from the mains supply.
There is the risk of electric shock!
C
Power cable plug must be within
easy reach after installation (do not
route it above the hob).
Plug the power cable into the socket.

3.4 Gas connection

WARNING: Product can be con-
nected to gas supply system only by
an authorised and qualified person
or technician with licence.
A
Risk of explosion or toxication due to
unprofessional repairs!
Manufacturer shall not be held re-
sponsible for damages arising from
procedures carried out by unauthor-
ised or unlicensed persons.
WARNING: Before starting any
A
work on the gas installation, discon-
nect the gas supply.
There is the risk of explosion!
Gas adjustment conditions and values are stated
on labels (or ion type label).
C
The gas type of your product is stat-
ed on type label placed bottom of
hob.
Built-In Hob / User Manual
3.4.1 Connecting the gas hose
For NG
• Natural gas installation must be prepared before
installing the product.
• There must be a pipe (Piping advised to be buyed
from a licensed installer), must comply with local
gas standard, at the outlet of the ins-tallation
for the natural gas connection of your product
and the tip of this pipe must be closed with a
blind plug. Service Representative will re-move
the blind plug during connection and con-nect
your product by means of a straight connec-tion
device (coupling).
• Make sure that the natural gas valve is readily
accessible.
• If you need to use your product later with a
different type of gas, you must consult the
Aut-horised Service Agent for the related con-
version procedure.
3.4.2 Connecting the gas hose
For LPG
• Have your product connected in a way that it will
be close to the gas connection and not gas lea-
kage will exist.
• Plastic hose to be used must not be longer than
125 cm.
• Install the clamp to the hose. Soak one end of
the hose (15 mm inner diameter) into boiling
water for one minute to soften it.
• Than, slip the softened end of the hose com-
ple-tely onto the sharp hose tip of your product.
Fi-nally, tighten the clamp completely with a
screwdriver.
A
WARNING: Risk of explosion and
suffocation!
Do not keep LPG cylinders in home.
15 / EN