Beko HISW 63222 SO Manuel D'utilisation page 26

7 Troubleshooting
Clanging is heard while the product
is heating and cooling.
• When the metal parts are heated, they may ex-
pand and make noise. >>> This is not a failure.
There is no ignition spark.
• Power is cut. >>> Check the fuses in the fuse
box.
The product is continuously spark-
ing.
• The effluent fluids may have penetrated into
the ignition mechanism under the control knobs.
>>> Unplug the product and wait for it to cool.
There is no gas.
• Main gas valve is shut off. >>> Turn on the gas
valve.
• The pipe has leaned. >>> Install the gas pipe
properly.
Burners are not burning properly or
at all.
• Burners are dirty. >>> Clean the burner compo-
nents.
• Burners are wet. >>> Dry the burner parts.
• Burner cap is not securely positioned. >>> Posi-
tion the burner cap correctly.
• Main gas valve is shut off. >>> Turn on the gas
valve.
• Gas cylinder is empty (when using LPG). >>>
Replace the gas cylinder.
• The burner knob/button has not been hold
pressed enough during ignition. >>> Ignite the
burner by pressing and holding for at least 3-5
seconds.
Consult the call centre if you can not
C
remedy the trouble although you
have implemented the instructions
in this section. Never attempt to re-
pair a defective product by yourself.
26 / EN
Built-In Hob / User Manual