Danby DDR050BCWDB-ME-6 Manuel Du Propriétaire page 9

OPERATING INSTRUCTIONS
BUCKETLESS MODE
The dehumidifi er can be used without the bucket installed. This means the dehumidifi er will continue to
remove water from the air and will not check if the bucket is installed.
Do not use bucketless mode without a drain hose attached. Ensure that the hose is securely connected
before turning on the dehumidifi er. Direct the other end of the drain hose to a place with unlimited capacity
such as a sink or fl oor drain. Directing the drain hose to a place with limited capacity could cause the
water to overfl ow.
To turn on bucketless mode:
1. Connect the drain hose to the dehumidifi er.
2. Connect the dehumidifi er to a power source. Do not install the water bucket.
3. "Eb" will show on the display.
4. Press and hold the fi ll level button and the up button at the same time for 3 seconds to set the
dehumidifi er to run without the bucket.
5. The bucketless indicator will illuminate on the display.
To turn off bucketless mode:
1. Press and hold the fi ll level button and the up button at the same time for three seconds.
2. Turn off the dehumidifi er. Ensure the bucket is installed before turning it back on again.
Important note: there is a micro switch on the bottom of the dehumidifi er that engages with the bucket.
Bucketless mode may be automatically turned off if this switch is pressed. Ensure that the space is clear and
that you do not touch the micro switch.
8