Default Setting - Danby DDR050BCWDB-ME-6 Manuel Du Propriétaire

OPERATING INSTRUCTIONS
FEATURES
1. Air outlet
2. Control panel
3. Handle
4. Water bucket
5. Casters
6. Air intake
7. Air fi lter (behind the grill)
1
2
3
4
5

DEFAULT SETTING

The default setting is continuous mode and high fan
speed. This means that when the dehumidifi er is
plugged in for the fi rst time it will run in continuous
mode with the fan speed set to high.
Press the mode button to change the mode, if
desired. Press the humidity adjust buttons to set the
desired humidity. Ensure that the set humidity is
lower than the ambient humidity.
3
6
7
OPERATION
• Place the dehumidifi er on a smooth, level fl oor
that is strong enough to support the appliance
with a full bucket of water.
• Do not place the dehumidifi er on carpeting as
this can block air fl ow around the appliance.
Do not force casters to move over carpeting as
the appliance can become unbalanced and spill
water.
• To maintain effi ciency, operate the appliance
in an enclosed area. Keep nearby doors and
windows closed.
• Maintain a minimum clearance of 40 cm (16
inches) around the air outlets and 20 cm (8
inches) on other sides of the appliance to allow
for proper air circulation.
• The recommended ambient operating
temperature is between 5°C (41°F) and 32°C
(90°F). Low ambient operating temperatures can
cause frost to form on the internal coils which
may affect performance.
• Any time the appliance is placed on its back or
side, it must be allowed to stand upright for 6
hours before plugging in to avoid damage to
internal components.
• For optimal performance, ensure that the
humidity setting is 10% lower than the ambient
humidity. It is normal for the ambient humidity to
vary up to 5% above or below the set humidity.
• It is recommended in normal conditions to set
the humidity between 40-45%.
• It is normal for the dehumidifi er to exhaust warm
air.
4