Control Unit For Default Machine Settings; Installation; Transport; Crane Hoisting - Elektra Beckum MIG MAG 232 EP Instructions D'utilisation

ENGLISH
25
LED welding voltage [V]
26
LED arc length [%]
27
7-segment display (3 digits)
The display shows:
− the value of the selected
parameter or
− an error message.
28
Parameter adjustment
to adjust the selected parameter.
3.5 Control unit for default
machine settings
29 30
34
33
29
Wire thread-in button
(Manual Wire Feed Drive)
30
Operating mode selector switch
(Mode Selection)
31
Burnback time selector switch
(Wire burnback control)
32
Gas type selector switch
(Gas Type)
33
Wire diameter selector switchr
(Wire Diameter)
34
Wire type selector switch
(Wire Type)

4. Installation

The individual components need to be
connected to each other before being
connected to the mains and before inital
operation. By default the components as
set for gas-shielded arc welding:
1. With the help of another person lift
the SWK (water cooling unit) and
place it on the Powerbox, to that its
feet stand between the pipes on the
rubber mat.
2. With the help of another person lift
the SDV (wire feed unit) and place it
onto the water cooling unit.
3. Connect the coolant hoses as illus-
trated below (see also the SWK
instructions).
14
4. Connect the cables as illustrated
below.
31
32

5. Transport

The Powerbox is mounted on a wheel
set. With fitted SDV and SWK the com-
plete welding machine is conveniently
moved to the workplace.
Danger!
Close
before relocating.
Danger!
Note the hight weight of the
welding machine. It may get out of
control,
ground!
Walk along the intended way, before
you set off with the welding machine.
Ask another person for assistance, if
necessary!
5.1

Crane hoisting

The welding machine can be hoisted by
crane.
Danger!
Remove
before hoisting.
Hoisting with the gas cylinder is for-
bidden!
the cylinder's valve
especially on sloping
the gas cylinder
1. Fit the hoisting straps as illustrated
below.
Caution!
At the workplace, secure the
machine against rolling away.

6. Preparing for Operation

6.1

Manual arc welding

When setting the machine for manual
arc welding, you must:
1. Check all connections.
Disconnect earth cable (- pole) and
welding current supply
(+ pole).
2. Connect earth cable to the Power-
box - pole).
3. Connect welding cable to the weld-
ing current supply cable (+ pole).
6.2

Gas-shielded arc welding

1. Check all connections. Disconnect
earth cable (- pole).
The welding current supply cable
(Powerbox) must be connected to
the connector plug of the welding
current supply (SDV).
cable