Inserting The Bobbin - Janome 8048 Manuel D'instructions

Inserting the bobbin

z Place the bobbin in the bobbin holder with the
thread running counter-clockwise.
q End of the thread
w Bobbin holder
x Guide the thread into the slot A on the front side
of the bobbin holder. Draw the thread to the left
sliding it between the tension spring blades.
e Slot A
c Continue to draw the thread lightly through the
tension blades until it slips into slot B.
r Tension blades
t Slot B
v Draw the thread to the back.
The bobbin should turn counterclockwise when
pulling the thread.
b Pull out about 10 cm (4") of thread and attach the
hook cover.
y Bobbin thread
u Align left edge of the hook cover.
z
q
x
c
t
v
t
b
y
22
w
e
r
u