Corded Buttonholes - Janome 8048 Manuel D'instructions

Corded Buttonholes

Machine setting
q Pattern
w LED display
e Foot
R: Automatic buttonhole foot
z With the buttonhole foot raised, hook the filler cord
on the cord spur on the back of the buttonhole foot.
Bring the ends toward you under the foot, and hook
the filler cord ends into the forks on the front of the
foot to hold them tight.
q Spur
w Forks
e Cord
x Lower the needle into the garment where the
buttonhole will start and lower the foot. Depress the
foot control and sew the buttonhole over the cord.
NOTE:
The sewing sequence is the same as the automatic
buttonhole.
c Remove the fabric and pull the left end of the cord
to tighten it. Cut the excess cord.
Refer to page 46 for opening the buttonhole.
q
z x
q
c
52
w e
w
e