OHAUS MB27 Guide De L'utilisateur page 12

EN-10
RS232 Commands
The RS232 Interface allows a computer to control the Analyzer, as well as to receive data such as displayed weight.
Command
ON
OFF
T
U
START
STOP
P
xP
PSN
PV
?
H
RS
RS:2400,7,N,2,X
RS232 Output
^^^^^^^^^^^^^^^^^^^^^^^^
MOISTURE DETERMINATION
OHAUS MB2x SN #########
Switchoff Mode
Drying Temp
Result Units
00:10 0.0%MC
00:20 0.0%MC
Elapsed Time
Initial Weight
Final Weigh
Final Result
^^^^^^^^^^^^^^^^^^^^^^^^
Function
Turns Analyzer ON
Turns Analyzer OFF
Same as pressing Tare
Same as pressing %g
begins a test
ends a test
Same as pressing Print
Interval Print x = Print Interval (1-3600 sec)
Print Serial Number
Print software version
Print Header
Header on or off
Print current RS232 settings
Change RS232 setting (The current RS232 setting can be displayed on the LCD by pressing
Print for 2 seconds while in standby mode.)
Baud:1200,2400,4800,9600,19200
Data Bits: 7 or 8
Parity: N = none, O = odd, E = even
Stop Bits: 1 or 2
Handshake: X = xon/xoff (software), R = RTS-CTS (hardware), N = none
The Analyzer will return "ES" for invalid commands.
All communication uses standard ASCII format.
Sent commands must terminate with a Line Feed or Carriage Return Line Feed (CRLF).
Header on
Header on
TIMED 10:00 Header on
100C Header on
%Moisture Header on
If Print pressed or print interval set.
If Print pressed or print interval set.
00:02:21
Printed at successful end of test.
8.560 g
Printed at successful end of test.
8.555 g
Printed at successful end of test.
0.0%MC
Printed at successful end of test.
MB27