Rona RFNC-001 Manuel De L'utilisateur page 19

OPERATING PROCEDURES
CAUTION:
 Keep the tool pointed away from yourself and others at all times.
 Always connect the tool to air supply before loading fasteners.
!
 Do not load fasteners with safety or trigger depressed.
 Always wear approved safety glasses and hearing protection when
preparing or operating this tool.
 Never use a tool that leaks air or needs repair.
MAINTENANCE
CAUTION: Disconnect tool from air supply before cleaning and inspecting the tool.
!
Correct all problems before operating.
CLEAN AND INSPECT DAILY
n Add pneumatic tool oil into the oiler regularly for all moving parts. Frequent, but not
excessive lubrication is required for the best performance. Oil added through the air
line connection will lubricate the inside parts. An automatic oiler is recommended,
but 2 drops of oil may be added manually into the tool's air intake at the male
quick-connect fitting (F, fig.1) at the beginning of each workday and after about every
hour of continuous use. Only a few drops at a time are necessary. More than this
will pool inside the tool and be expelled from the tool's exhaust during firing. USE
ONLY PNEUMATIC TOOL OIL. Do not use oil with detergents or other additives, as
these can cause accelerated wear on the seals.
n Check the filter of the compressor weekly. Open drain cock to drain all water and
contaminants out of the air tank.
n Wipe the tool clean.
n Blow the tool clean using high compressed air, and then use non-flammable cleaning
solutions to wipe exterior of tool if necessary.
n Do not soak tool in cleaning solutions. Such solutions can damage internal parts.
The exposed portion of the small piston rod and feed hook must be kept clean.
n Inspect trigger and safety mechanism daily to ensure system is complete and
functional.
n Keep all screws tight. Loose screws can cause personal injury or damage to the tool.
Check if there are worn and damaged parts. If any, please replace immediately.
TROUBLESHOOTING
WARNING: Stop using the tool immediately if any of the following problems occur.
Serious personal injury may result. Any repairs or replacements must be done by
!
qualified personnel or by an authorized service centre only.
CAUTION:
 Disconnect the tool from air supply before performing any service procedure.
!
 When inserting new or re-installing O-rings, make sure they are clean and lubricated
with an O-ring lubricant.
19
070711