Rona RFNC-001 Manuel De L'utilisateur page 17

OPERATING PROCEDURES
LOADING FASTENERS
1. After reading and understanding this entire manual, connect tool to the air supply.
CAUTION:
 Keep tool pointed away from yourself and others at all times.
 Always connect tool to air supply before loading fasteners
!
 Do not load fasteners with trigger or safety pressed.
 Always wear approved safety glasses, and hearing protection when preparing or
operating the tool.
 Never use a tool that leaks air or needs repair.
2. Depress cover-plate latch (L, fig.4).
Fig. 4
3. Open cover plate (K, fig.5)
Fig. 5
4. Open the lower magazine (J, fig.2).
5. Place a coil of nails in the lower magazine.
6. Rotate magzine height adjustment knob (G, fig.6) to adjust the lower magazine
according to the nails' length. The highest position is used for 2" (50 mm) nails while
the lowest position is used for 3-9/16" (90 mm) nails. For all nails between minimum
and maximum, adjust lower magzine accordingly.
7. Close lower magazine.
8. Draw the nails out and position the second nail on to the feed hook (M, fig.5).
9. Close cover-plate and latch (L, fig.4).
10. Rotate the directional exhaust deflector (C, fig.2), so that the exhaust air blast will be
directed away from the operator.
Fig. 6
17
070711