Bosch SHE66C Guide D'entretien Et D'utilisation page 14

Masquer les pouces Voir aussi pour SHE66C:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating the Dishwasher
Interrupting a Cycle
NOTE: Should you need to interrupt a cycle (to
add or remove an item, to add detergent, etc.), it
is best to do so within the first 30 minutes of the
cycle.
Open the dishwasher door far enough to expose
the control buttons.
Press the On/Off button.
WARNING
You could be seriously scalded if you allow
hot water to splash out of the dishwasher.
OPEN THE DOOR CAREFULLY during any
wash or rinse cycle. Do not fully open the
door until water noises have stopped.
Wait at least ten seconds or until water noises
stop before opening the dishwasher door.
To resume the cycle, press the On/Off button and
shut the dishwasher door.
Canceling or Changing a Cycle
To cancel or change a cycle, open the dishwasher
door far enough to expose the control buttons
then press and hold for three seconds the two
buttons labeled "Cancel Drain" as shown in
Figure 27.
Figure 27
Cancel Drain
Close the door and wait until the dishwasher
completes the cycle (approximately 1 minute).
Open the door and press the ON/OFF button.
You may now begin a new cycle.
Child Safety Latch
(models SHE66C and SHE58C only)
Your dishwasher is shipped from the factory with
the Child Safety Latch disengaged and in the
normal operating mode. Pull on the door handle
to open the door. The Child Safety latch activation
12
(continued)
lever is located in the recess for the door handle.
You must look up into the recess to find the Child
Safety Latch activation lever (see Figure 28).
To activate the Child Safety Latch insert a
matchstick or other non-metal object into the
opening as shown in Figure 28. The activation
lever will release and move toward the left.
You have now activated the Child Safety Latch.
Each time you open the dishwasher door you will
need to slide the activation lever to the right
to release the door locking mechanism, you can
then pull the door open (See Figure 29). After
you open the door you should release the Child
Safety Latch Activation lever and let it slide back
toward the left.
To deactivate the Child Safety Latch insert a
matchstick or other non-metal object into the
opening as shown in Figure 30. Slide the
activation lever to the right and hold. Remove the
matchstick and release the lever. The feature has
now been deactivated and you can open the door
by pulling the handle.
Figure 28
Figure 30
Figure 29

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Shx56cShv56cShx57cShv57cShy56aShe58c

Table des Matières