Disinfecting The Whirl System - DURAVIT Combi-System L Notice D'utilisation

7.2

Disinfecting the whirl system

How often?
> Disinfect the whirl system before using it for the first time, and then after every tenth
bath, but at least once a month and after a long period of no use.
> Add a high dosage of disinfectant to the system in the case of heavy soiling.
How?
CAUTION
Sodium hypochlorite irritates the skin.
> Observe the safety instructions on the disinfectant label.
> Do NOT bathe in the whirltub while disinfecting it.
> Ensure that the room is well-ventilated during the disinfection process.
> Fill the tub with cold water.
> Add a non-foaming cleaning agent (2.5 - 3% sodium hypochlorite) to the water, de-
pending on the type of disinfection (see table 2).
Disinfection
Regular disinfection
High dosage of disinfectant
Table 2: Disinfectant dosage recommendations
> Switch on all jets.
> Select the highest intensity.
> Switch off the air jets again after approx. 10 seconds.
> All jets switch off automatically after approx. 20 minutes.
> Switch the air jets on again for approx. 10 seconds.
> Repeat the procedure described above to switch on the jets at least twice over a pe-
riod of 2 hours.
> Drain the water and rinse the tub.
> Fill the tub again with cold water.
> Switch on all the jets for 30 seconds.
> Drain the water.
> Wait until the tub has emptied completely.
> The air cleaning process starts after about 2 minutes.
> Wait until the air cleaning process is finished (about 4 minutes).
> Switch off the main switch.
> Repeat the process as necessary.
Dosage
0.5 l of cleaning agent per 100 l of water
5 l of cleaning agent per 100 l of water
35