Maintenance - Livassured NightWatch Mode D'emploi

» Place the armband around the upper
» The base station will now blink green
» Move the pyjama sleeve back down
» The wearer will now go to sleep.
EN
» If the wearer rises or gets out of
See 'Signals from the arm module and
the base station' for all signals and what
to do in case of issues.
PLEASE NOTE: Check that both green
LEDs are equally bright as soon as the arm
module, switched on, is removed from the
charger. After a while, one of the green
LEDs may switch itself off to optimise the
heart rate measurement, this is normal.
PLEASE NOTE: As soon as the arm module
is disconnected from the charger, the base
station will emit a beep every two seconds
until the heart rate has been detected.
Once the heart rate has been detected,
LED 5 (green) will start to blink or light up
74
NightWatch user manual v4.0 v3.indd 74 NightWatch user manual v4.0 v3.indd 74
arm, between the shoulder and the
thickest part of the biceps, with the
arm module facing forward on the
upper arm so that the wearer will not
lie on it when lying on his/her side.
when the heart rate is detected.
the arm if necessary.
Once the wearer is lying down quietly
and the arm module has detected
very little or no movement at all for
two minutes, the more sensitive
movement and heart rate algorithms
become active. When this occurs, the
blinking green LED for the heart rate
changes to a continuous green LED.
bed, the more sensitive movement
and heart rate algorithms will be
temporarily switched off , until the
wearer is lying down quietly.
continuously. Check this regularly.
PLEASE NOTE: After use, connect the arm
module to the charger immediately. Do not
switch off the arm module during charging
or during use. Only switch off the arm
module when returning it for service or
during transport to a diff erent location.
PLEASE NOTE: Please ensure the base
station is never covered during use.
PLEASE NOTE: Please ensure that the
base station is switched on before the arm
module is removed from the charger.
5.5

Maintenance

The NightWatch does not require
periodic maintenance. For hygiene
reasons, however, the arm module
should be cleaned regularly with a damp
cloth and a disinfectant, such as alcohol.
PLEASE NOTE: Clean the arm module
regularly to reduce the risk of the wearer
developing skin irritation.
PLEASE NOTE: Do not use water to clean
the arm module and base station, please
use a damp wipe. The elastic band is
washable.
v4.0 NightWatch
15-07-20 16:12 15-07-20 16:12