Livassured NightWatch Mode D'emploi page 71

Masquer les pouces Voir aussi pour NightWatch:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 90
PLEASE NOTE: In order to achieve as
accurate detection as possible of any
epileptic seizures, the arm module should
be worn on the upper arm (biceps) and
directly on the skin. If the wearer is
wearing a pyjama top or other long-
sleeved garment, please ensure the sleeve
is wide enough to wear the arm module
underneath.
Check the tightness of the band. The
armband will probably be a little too
loose. The correct fi t allows one fi nger to
just about fi t under the strap.
If the arm band feels too loose:
Remove the armband, pull the elastic
strap further through the clips. Try again.
If the arm band feels too tight:
1. Using a fi ngernail, press the clips from
below to remove them from the arm
module.
2. Adjust the clips to make the elastic
strap longer.
3. Place the clips in the slots again.
Try again.
NightWatch
NightWatch user manual v4.0 v3.indd 71
NightWatch user manual v4.0 v3.indd 71
Adjust the strap until it is both
comfortable for the wearer and fi ts
snugly around the arm. Finally, cut the
excess ends off the strap so that they do
not cover the green heart rate sensors.
There is no cause for concern if the
arm module leaves an imprint on the
arm after a night's sleep, as long as this
imprint fades by itself within half an hour.
PLEASE NOTE: Wearing the arm module
can cause skin irritation in some wearers,
such itching or a temporary rash. Regularly
cleaning the arm module can help resolve
this. Frequently switching arms can also
help. If the problem persists, there are
special plasters available which can be
applied over the arm module and which
will relieve the symptoms in most cases.
Please contact your supplier.
PLEASE NOTE: Please ensure the armband
has been adjusted to the correct size for
the patient before use, so that it is not too
tight or too loose.
PLEASE NOTE: The elastic strap may
protrude slightly on both sides of the dark
underside. However, ensure that the ends
do not cover the green light-up sensors. The
band can be made tighter by pulling the
ends. The band is very soft and the wearer
will not experience discomfort from the
protruding ends.
PLEASE NOTE: The elastic strap supplied
measures 1 metre. This can be used to
make a new armband when the wearer
outgrows the fi rst strap.
v4.0
EN
71
15-07-20 16:12
15-07-20 16:12

Publicité

Table des Matières
loading

Table des Matières