iwc INGENIEUR AUTOMATIC 3570 Mode D'emploi page 30

R E M O V I N G I N D I V I D U A L L I N K S
A N D AT TA C H I N G T H E B R A C E L E T
sitting correctly. Keep the surplus links and separating tool in a
safe place for use in any adjustments at another time.
— 3 0 —
Repeat steps 1 to 3 at the distance from
the first point of separation you have
just determined. Remove the unneces-
sary links and reassemble the shortened
bracelet. Slide the hinged link into the
bracelet sideways (1).
Using the special tool provided, you can
now push down the fixing bolt (2) and, at
the same time, slide the hinged link back
into the bracelet until it lies flush (3). The
fixing bolt must be aligned with the upper
edge of the securing link. It is important
that you check that the hinged link is
I N G E N I E U R A U T O M AT I C