Standard Installation - Bosch Power Xpress EL-50600-300 Instructions D'installation

en | 6 | Power Xpress™ Bollard Charge Station Installation Guide
7.0

Standard Installation

1. Lay down the bollard box and remove the banding.
2. Lift the top off the box and remove the bollard from the
packaging material.
3. Remove the upper cover from the bollard assembly by
removing the cable-management retaining screws (E) on
the rear of the bollard.
4. Remove plastic bag containing locating set screw (not
shown) from inside bollard.
NOTE: The upper and lower plastic bollard covers are a matched
set and cannot be used inter-changeably with those from
other bollards.
The standard installation design for the Power Xpress Bollard is a
bolt-down external plate.
The standard diameter of the bollard is approximately 7 in. The
bollard height will vary with the application.
578988 | REV. A | 28.10.2016
CAUTION: Read all instructions before installing
the EVSE.
WARNING: Main service power must be off and
disconnected before attempting to install the
EVSE.
WARNING: The bollard weighs 20 lb per foot, and
the bottom end is significantly heavier than the
top end. Take proper precautions and use safe
lifting practices when lifting the bollard.
CAUTION: All adapter and connection fittings must
be classified as liquid-tight. The following types of
flexible conduit are recommended: LFMC (liquid-
tight flexible metal conduit), LFNC-B (liquid-tight
flexible nonmetal conduit), or LFNC-A (liquid-tight
flexible nonmetal conduit).
5. Place the bollard where it is to be installed and drill holes.
6. Install the 3/4 in. anchor bolts in accordance with industry
standards for the type of mounting being performed.
NOTE: Depending on the type and size of the conduit stand
pipe, a variety of adapters may be used to convert the
stand pipe to 1/2-in. liquid-tight flexible conduit.
7. Slide the wires through the required adapters and the 1/2-in.
liquid-tight flexible conduit.
Bosch Automotive Service Solutions Inc.