Bosch Power Xpress EL-50600-300 Instructions D'installation page 12

en | 10 | Power Xpress™ Bollard Charge Station Installation Guide
31. Carefully lower the upper plastic cover down onto the bol-
lard base.
32. Use a small flat-blade screwdriver or similar tool to guide the
upper plastic cover into the seal.
578988 | REV. A | 28.10.2016
33. While gently pressing down on the upper plastic cover,
carefully slide the screwdriver around the bollard to extend
the upper lip of the seal over the upper plastic cover. The
upper cover may need to be tapped gently to fully seat it in
the seal.
CAUTION: Use care not to cut or damage the seal
during this procedure.
NOTE: When the upper plastic bollard cover is fully seated, the rear
cable-management holes will be in line with the threaded
holes in the steel portion of the bollard base and the rubber
cable grommet will be centrally located with respect to the
rubber seal. Verify the cable-management holes and the
rubber cable grommet are each properly aligned.
34. Use a 5/16-in. hex-head wrench to install the rear cable-
management hook with the two cable-management retain-
ing screws. The torque on the cable-management retaining
screws should be 60 ± 5 in-lb (6.8 ± 0.55 Nm).
35. Loop the cable onto the cable-management holder.
Bosch Automotive Service Solutions Inc.