Bosch Power Xpress EL-50600-300 Instructions D'installation page 11

25. Apply decal to the front of the EVSE cover.
26. Continue lowering the EVSE until the front edge of the EVSE
bottom cover rests on the ledge in the bollard front opening.
WARNING: The lower edge of the EVSE bottom
cover must rest on the ledge of the bollard. Failure
to position the EVSE correctly in the opening will
cause damage to the EVSE when the locating set
screw is tightened.
WARNING: Never use any other size set screw to
secure the EVSE in place. If the set screw is too
long, it will prevent installation of the upper cover.
27. Push any excess conduit down into the bollard. A loop will
extend above the bollard and fit in the top cover.
Bosch Automotive Service Solutions Inc.
Power Xpress™ Bollard Charge Station Installation Guide | 9 | en
28. Install the locating set screw to 50 ± 5 in-lb (5.5 ± 0.55 Nm).
29. Position the strain relief at the bottom of the side slot metal
mounting bracket in the steel bollard. Position such that the
rubber grommet (D) seats on the opening of the lower plastic
bollard cover.
30. Tighten the inner strain-relief nut (A) inside the bollard hand
tight. Using expandable pliers, tighten the nut an additional
1/4 turn.
NOTE: Do not overtighten the strain-relief nut. The grommet
may pull through.
578988 | REV. A | 28.10.2016