Bosch Power Xpress EL-50600-300 Instructions D'installation page 13

36. Switch the main circuit breaker to the ON position and verify
that the Power LED is illuminated solid green and the Status
LED is illuminated solid amber on the EVSE.
Bosch Automotive Service Solutions Inc.
Power Xpress™ Bollard Charge Station Installation Guide | 11 | en
8.0 Power and Status LED
Indications
Power LED Status LED
(Off ) (Off )
Green
Amber solid
solid
Green
Green solid
solid
Green Green
solid flashing
1–2 red
Green flashes
solid every 2
seconds
Solid red,
Green then green
solid flash every
2 seconds
Green Red
solid flashing
Green
Red solid
solid
Green
(Off )
solid
*See "Troubleshooting" for suggested solutions.
- No illumination
- Solid illumination
- Flashing illumination
Condition
No service supply
power
Charge Station
powered; vehicle
coupler not
connected
Waiting to charge
Vehicle charging
Pilot charging
error*
Ground fault
detected*
Ground monitor
interrupted*
Operation fault*
Operation fault*
578988 | REV. A | 28.10.2016