Bosch Power Xpress EL-50600-300 Instructions D'installation page 10

en | 8 | Power Xpress™ Bollard Charge Station Installation Guide
17. Gently guide the EVSE body down through the bollard until it
rests on the top of the tapered guide bracket.
18. Mark 1/2-in. liquid-tight flexible conduit for length based on
the required radius bend to attach to the top of the EVSE.
19. Cut 1/2-in. liquid-tight flexible conduit to length. Do not cut
wires
20. Install approved, liquid-tight fittings to attach 1/2-in. liquid-
tight flexible conduit to top of EVSE.
NOTE: All connections must be liquid-tight.
578988 | REV. A | 28.10.2016
21. Feed wires into the hole in the top of the EVSE and attach
1/2-in. liquid-tight flexible conduit with a liquid-tight fitting.
22. Cut wires to length.
23. Strip wires and wire them into the EVSE. Refer to label on
inside of EVSE cover or details on circuit board. Torque
terminal screws to 10.62± 1 in-lb (1.2 ± 0.12 Nm).
24. Install EVSE cover.
Bosch Automotive Service Solutions Inc.