HP Photosmart C8100 Série Guide D'utilisation page 24

Masquer les pouces Voir aussi pour HP Photosmart C8100 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Chapter 3
5.
Push the main input tray back into the HP All-in-One.
6.
Pull the output tray extender toward you, as far as it will go.
NOTE:
Load 10 x 15 cm (4 x 6 inch) photo paper
You can load up to 10 x 15 cm (4 x 6 inch) photo paper into the photo tray of the
HP All-in-One. For the best results, use 10 x 15 cm (4 x 6 inch) HP Premium Plus Photo
Paper or HP Premium Photo Paper.
To load up to 10 x 15 cm (4 x 6 inch) photo paper in the photo tray
1.
Raise the output tray, and then pull out the photo tray.
2.
Insert the stack of photo paper into the photo tray with the short edge forward and the
glossy side down. Slide the stack of photo paper forward until it stops.
If the photo paper you are using has perforated tabs, load the photo paper so that the
tabs are closest to you.
3.
Slide the paper-length and paper-width guides inward against the stack of photo
paper until the guides stop.
Do not overload the photo tray; make sure the stack of photo paper fits within the
photo tray and is no higher than the top of the paper-width guide.
4.
Push in the photo tray, and then lower the output tray.
24
HP Photosmart C8100 All-in-One series
When you use legal-size paper, leave the tray extender closed.

Publicité

Chapitres

Table des Matières
loading

Table des Matières