HP Photosmart C8100 Série Guide D'utilisation page 20

Chapter 2
Restore network defaults
You can reset the network settings to what they were when you purchased the
HP All-in-One.
CAUTION:
order to restore this information, you will need to run the Wireless Setup Wizard again.
1. Touch Setup on the display.
2. Touch Network.
NOTE:
to scroll through all the menu options.
3. Touch Restore Network Defaults.
4. Touch Yes or No.
Turn the wireless radio on and off
In order to stay connected to a wireless network, the wireless radio must stay on. When
the radio is on, the blue light on the front of the HP All-in-One is lit. However, if the
HP All-in-One is connected to a wired network or you have a USB connection, the radio
is not used. In this case you might want to turn the radio off.
1. Touch Setup on the display.
2. Touch Network.
NOTE:
to scroll through all the menu options.
3. Touch Wireless Radio.
4. Touch On or Off.
Print the wireless network test
The wireless network test performs a series of diagnostic tests to determine whether
network setup is successful. If an issue is detected, a recommendation on how to correct
the issue will be included on the printed report. You can print the wireless network test at
any time.
1. Touch Setup on the display.
2. Touch Network.
NOTE:
to scroll through all the menu options.
3. Touch Wireless Network Test.
The Wireless Network Test prints.
Change advanced network settings from the control panel settings
The advanced network settings are provided for your convenience. However, unless you
are an advanced user, you should not change any of these settings.
20 HP Photosmart C8100 All-in-One series
This will erase all wireless setup information that you have entered. In
If the menu option you want is not visible on the screen, touch
If the menu option you want is not visible on the screen, touch
If the menu option you want is not visible on the screen, touch
or
or
or