Integrated Wireless Wlan 802.11 Network Setup - HP Photosmart C8100 Série Guide D'utilisation

Chapter 2
Connect the HP All-in-One to the network
To connect the HP All-in-One to the network, use the Ethernet port on the back of the
device.
To connect the HP All-in-One to the network
1. Remove the yellow plug from the back of the HP All-in-One.
2. Connect the Ethernet cable to the Ethernet port on the back of the HP All-in-One.
3. Connect the other end of the Ethernet cable to an available port on your Ethernet
router, switch, or wireless router.
4. Once you have connected the HP All-in-One to the network, install the software as
described in

Integrated wireless WLAN 802.11 network setup

For optimal performance and security in your wireless network, HP recommends you use
a wireless router or access point (802.11) to connect the HP All-in-One and the other
network elements. When network elements are connected through a wireless router or
access point, this is called an infrastructure network.
10 HP Photosmart C8100 All-in-One series
"Install the software for a network connection" on page 17.