ZUMEX Soul Manuel De L'utilisateur page 13

7
!
9
Zumex recommends using CITROCLEAN to improve the cleaning results of
the machine, especially to eliminate waxes.
8
10
After removing the lid, take out the Filter using the adhesive flange. Then remove
7
the entire pressing unit and shafts, pulling the grip upwards from its central
support.
Warning! Be careful with the cutting area!
!
Be careful with the blade when removing the pressing unit and shafts.
Important! Do not pull the soft ejectors from the filter.
If you consider it necessary, you can also remove the Feeder flange, situated on
the other cover of the Juice extraction unit.
Always remember to put the parts back correctly after cleaning for correct juice
extraction.
8 Cleaning is easy. Rinse the parts with water using your hand or a sponge to remove
the remains of pulp.
To remove the Pressing units for in-depth cleaning of their parts, turn the
9
Fasteners of the pressing units a quarter of a turn to remove the Lower pressing
unit and the Upper pressing unit.
You can also put the parts in the dishwasher. You must use the soap, salt and
brightener correctly, so that the parts remain shiny.
Important! The Shaft unit with its central support is an indivisible unit.
You must not remove it.
To assemble, slide the respective pressing unit along the guide until it is in place.
Make sure that both pressing units couple perfectly. Turn the
pressing units a quarter of a turn and make sure that the fasteners correctly
secure the pressing units.
If necessary, you can clean the inside of the metal chassis with a soapy cloth. Then,
10
rinse and dry. Do not use a rough cloth as this may damage the machine surface.
To clean the outside of the machine, you can use a damp cloth or a soapy sponge
– with neutral soap.
Fasteners of the
23