Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
careful inspection by qualified personnel.
•Only connect the unit to the mains supply/ electrical
outlet if plant/outlet capacity is suitable for its maxi-
mum power. If otherwise, immediately seek assi-
stance from a professionally qualified person.
•If the product falls or receives a strong blow, imme-
diately have it inspected at an authorised Vortice
Technical Assistance Centre.
•Switch off the unit in the event of malfunction and/or
failure. Contact an authorised Vortice Technical
Assistance Centre immediately and request the use
of original Vortice spare parts for any repairs.
•Turn off the unit switch when it is not in use.
•Position the product a suitable distance from walls,
objects, etc.
•The electrical specifications correspond to the ones
on the data label A (fig.2).
The unit must be installed by
•
professionally qualified person-
nel only.
An omnipolar switch is required
•
for installation, with a contact
opening distance that is equal to
or greater than 3 mm.
Units assembled with a Light Kit
•
must be equipped with lamps
for E27 type lamp holders and
must not exceed the maximum
absorption limit in Watts indica-
ted on the data label or inside
the Instructions Manual.
Tools needed for assembly
Figure A
Supplied accessories
Figure B
Installation
Figures: 4 - 38
Please follow the instructions below for installation.
1. Make sure that the ceiling where the unit is to be
installed is structurally sound to support the weight
of the product.
2. Be careful that the anchoring devices do not com-
promise the structural resistance of the ceiling
where the unit is to be installed.
3. Use dowels that can ensure material stays gripped
to the ceiling where the unit is to be installed.
8
Operation
Caution!!! The information described in this chapter
only relates to use of the VORTICE Code 12829
POT-R regulator. Operation is possible with other
potentiometers provided they have the following cha-
racteristics:
1 - Resistive value 10kOhm
2 - Integrated or external switch
Fans are turned on by means of a switch integrated
into the potentiometer. Start from the stand-by posi-
tion on the knob and turn it clockwise. You will hear
a click when the switch closes and then, when the fan
is switched back on, you will hear a brief buzzer tone
accompanied by a quick ignition of the LED.
The speed setting is continuous. Up to about half the
potentiometer scale, product operation is on ventila-
tion; from half to full scale, it is in reverse. Fan passa-
ge to reverse is highlighted by two short buzzer tones
and two quick ignitions of the LED, while the reverse-
to-ventilation passage is highlighted by a brief buzzer
tone and a quick ignition of the LED (fig.39).
The area of hysteresis (fig.40) corresponds to the
maximum speed during operation in ventilation mode
and the minimum speed in reverse mode.
Shut-down occurs by completely rotating the knob in
the counter-clockwise direction. A long buzzer tone
and a long LED ignition will indicate shut-down.
The product can be remotely operated by means of
the VORTICE Code 21200 TELENORDIK ECO
remote control
Cleaning
Figures: 41 - 43.
Before performing any cleaning or maintenance ope-
rations, turn the unit switch off and disconnect its
plug from the power supply.
Electrical connections
Figures: 44 - 45
Dismantling caps
Figures: 46 - 49.
Publicité
Table des Matières
