Operation - Beurer LB 50 Mode D'emploi

Air humidifier placement
Caution
Place the appliance so that the steam nozzle is not pointing directly at a wall. The exiting moisture might
otherwise cause damage to walls, particularly to wallpaper.
• Place the air humidifier on a firm, even, water-resistant surface.
• Position the mains cable [14] so that the appliance cannot be knocked over.
Connecting mains cable
WARNUNG
• Before putting the appliance into operation, make sure that the cable [14] is not damaged. Never
operate the appliance if the mains cable is damaged.
• The appliance may only be operated with the voltage indicated on the rating plate.
Connect your air humidifier to the mains by plugging the mains plug [14] into the wall socket.
Filling the tank
Before using the appliance for the first time, the tank must be filled. See chapter 7 ‚Operation', in the section
on ‚Filling the Tank'.

7. Operation

1. Filling the tank
Fill the tank when putting the appliance into operation for the first time or if the red indicator [A] is illuminated,
indicating that the water level is too low.
IMPORTANT
• Only ever use fresh tap water to fill the tank.
• Never put any additives into the water.
• Make sure that the tank catch with seal on the base of the water tank is tightly fastened before put-
ting the appliance into operation.
• Remove the cover [1] from the air humidifier.
• Pull the water tank out of the air humidifier using the handles [7]. Unscrew the tank catch [9] from the tank.
• Rinse out the water tank with clean water.
• Fill the water tank with cold tap water.
• Screw the tank catch onto the water tank. Place the water tank in the air humidifier.
• Place the cover [1] on top of the air humidifier.
2. Switching on the appliance
IMPORTANT
• Never switch on the air humidifier without the water tank or steam tower [3].
• Press the ON/OFF button [D] in order to switch on the air humidifier. The green indicator [B] is illuminated.
• Before the steam starts exiting: Rotate the steam nozzle [2] so that the steam exits in the required direction.
After a few minutes, the appliance starts to give off steam. The green indicator [B] is illuminated while the
appliance is switched on and connected to the mains.
3. Selecting the amount of steam
• Select the amount of steam using the steam button [C]
Level 1: minimum steam (approx. 150 ml/h)
Level II: maximum steam (approx. 400 ml/h)
After a few minutes, the appliance alters the amount of steam generated.
.
17