Operation - Beurer LB 50 Mode D'emploi

5 O
PERATION
Filling the tank
1
Fill the tank when putting the appliance into operation for the first time or if the red
indicator [A] is illuminated, indicating that the water level is too low.
IMPORTANT
Only ever use fresh tap water to fill the tank.
Never put any additives into the water.
Make sure that the tank catch with seal on the base of the water tank is tightly
fastened before putting the appliance into operation.
Remove the cover [1] from the humidifier.
Pull the water tank out of the humidifier using the handles [7]. Unscrew the tank
catch [9] from the tank.
Rinse out the water tank with clean water.
Fill the water tank with cold tap water.
Screw the tank catch onto the water tank. Place the water tank in the humidifier.
Place the cover [1] on top of the humidifier.
Switching on the appliance
2
IMPORTANT
Never switch on the humidifier without the water tank or steam tower [3].
Press the ON/OFF button [D] in order to switch on the humidifier. The green
indicator [B] is illuminated.
Before the steam starts exiting: Rotate the steam nozzle [2] so that the steam exits
in the required direction.
After a few minutes, the appliance starts to give off steam. The green indicator [B] is
illuminated while the appliance is switched on and connected to the mains.
Selecting the amount of steam
3
Select the amount of steam using the steam button [C]
Level 1:
Level II:
After a few minutes, the appliance alters the amount of steam generated.
Switching off the appliance
4
Press the ON/OFF button [D] in order to switch off the appliance. The green
indicator light [B] goes out.
minimum steam (approx. 150 ml/h)
maximum steam (approx. 400 ml/h)
The appliance is suitable for continuous operation. We recommend,
however, that it is not operated for any length of time without
supervision (night operation).
The appliance has an automatic switch-off function when the tank is
empty.
15
.