Starting Operation - Bosch PSR Select Notice Originale

OBJ_BUCH-1564-001.book Page 32 Thursday, December 15, 2011 8:36 AM
32 | English
Operation

Starting Operation

Reversing the Rotational Direction (see figure E)
The rotational direction switch 8 is used to reverse the rotational direction
of the machine. However, this is not possible with the On/Off switch 10
actuated.
Right rotation: For driving in screws, push the rotational direction switch
8 left to the stop.
The indicator for right rotation 4 lights up when the On/Off
switch 10 is actuated and the motor is running.
Left Rotation: For loosening or unscrewing screws, push the rotational
direction switch 8 right to the stop.
The indicator for left rotation 6 lights up when the On/Off switch
10 is actuated and the motor is running.
Switching On and Off
Note: The power tool can only be switched on when the sliding switch 7
has been pushed to the front position.
To start the machine, press the On/Off switch 10 and keep it pressed.
The power light 12 lights up when the On/Off switch 10 is slightly or com-
pletely pressed, and allows the work area to be illuminated when lighting
conditions are insufficient.
To switch off the machine, release the On/Off switch 10.
The drill spindle is locked when the On/Off switch 10 is not pressed.
When the drilling spindle is locked, do not press the On/Off switch
10 for more than 15 seconds. Otherwise the power tool can be
damaged.
Battery Charge-control Indication
The battery charge-control indicator 5 indicates the charge condition of
the battery when the power tool is switched on.
LED
Continuous lighting, green
Continuous lighting, red
2 609 005 858 | (15.12.11)
Capacity
≥ 30%
< 30%
Bosch Power Tools