Bosch PSR Select Notice Originale page 30

OBJ_BUCH-1564-001.book Page 30 Thursday, December 15, 2011 8:36 AM
30 | English
The Lithium-Ion battery can be charged at any time without reducing its
service life. Interrupting the charging procedure does not damage the bat-
tery.
The Lithium-Ion battery is protected against deep discharging by the
"Electronic Cell Protection (ECP)". When the battery is empty, the ma-
chine is switched off by means of a protective circuit: The inserted tool no
longer rotates.
Do not continue to press the On/Off switch after
WARNING
the machine has been automatically switched
off. The battery can be damaged.
The battery is equipped with a NTC temperature control which allows
charging only within a temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this manner.
When the battery charge-control indicator 5 lights up red while the
On/Off switch 10 is depressed half way, then the battery has less than
30% of its capacity and should be charged.
The charging procedure begins as soon as the mains plug of the battery
charger is plugged into a socket outlet and the charge connector 14 is
plugged into the socket 9 on the bottom of the handle.
Due to the intelligent charging method, the charging condition of the bat-
tery is automatically detected and the battery is charged with the opti-
mum charging current, depending on battery temperature and voltage.
The battery charge-control indicator 5 indicates the charging progress.
The indicator flashes green during the charging procedure. When the
battery charge-control indicator 5 no longer lights up, the battery is com-
pletely charged. When the battery charge-control indicator 5 lights up
red, the battery temperature is too high.
During the charging procedure, the handle of the machine warms up. This
is normal.
Disconnect the battery charger from the mains supply when not using it
for longer periods.
The power tool cannot be used during the charge procedure; it is not de-
fective when inoperative during the charging procedure.
Observe the notes for disposal.
2 609 005 858 | (15.12.11) Bosch Power Tools