Scheppach Molda 5.0f Mode D'emploi page 54

Documentation
Page 54
7
Groove cutter
Fig. 7
upper position with spindle
bushings "
spindle ring "
J
groove.
8
Groove cutter "
pairs with spindle bushings
Fig. 8
B
" " and intermediate rings "
for moulding a groove. Spindle
ring "
groove cutter minimally inset
into Table plate "
Insert the groove cutters at
90° offset to each other.
9
Saw blade "
Fig. 9
as initial operation for cutting a
deep rebate. Spindle ring "
inlaid.
10
9
Fig. 10 As
operation for groove
cutting.
13
Facing cutter "N" aligned in
upper position, spindle ring
"D" removed.
Fig. 13
Caution!
Remove spindle ring before
inserting the facing cutter.
14
Facing cutter "N" aligned in
upper position – mounted
revolved through 180°.
Spindle ring "D" removed.
Fig. 14
Caution!
Pay attention to spindle
direction.
Set reversing switch to
"reverse drive".
"J"
aligned in
B
" and inlaid
D
" for moulding a
J
" aligned in
K
"
D
" removed – lower
C
".
L
" for grooving or
D
"
but as second
1902103850