Scheppach Molda 5.0f Mode D'emploi page 52

Documentation
Insert moulding Figure U
Figure U
The moulding fence and the miter gauge with the
clamping device should be used for insert
moulding tasks.
Cover the moulding tool with the overhead roller
guard assembly.
Place the workpiece at the anti-kickback device,
swivel it inwards and feed it forwards.
Corrosion protection: (accessory) article no.: 6100 9800
If the machine is not used for a period of time, the table surface should be sprayed with an anti-corrosion
spray.
Page 52 1902103850