Correct Set-Up - Scheppach Molda 5.0f Mode D'emploi

Documentation
Figure Q
Inserting the guide rail
The guide rail is inserted into the moulding fence at
the right height to safely bridge the moulding fence
distance when working with short workpieces.
The guide rail is clamped by pushing the two
aluminium fence profiles together.
Additionally, you may construct a bridging board to be
placed between the aluminium fence profiles, or a
fronting board to be placed in front of the fence
profiles.

Correct set-up

The requirement for working safely!
Select the moulding tool and appropriate insert ring.
-
Check the moulding tool. Replace damaged moulding blades. Select the speed in accordance with the
-
moulding tool and required procedure. Note the "Optimum speed range for moulding tools on
spindle moulders" sticker on your machine.
Set the working height and depth and the incline of the moulding spindle with the motor turned off.
-
Set the moulding fence and safety device in accordance with the required procedure.
-
- To ensure safe working, check the important securing screws of the moulding fence or the table
extension and tighten if necessary.
Perform a test moulding – never work without a safety device.
-
Replacing the moulding tool
Figure R
When replacing the moulding tool, pay attention
to the insert ring. Depending on the moulding
tool, the insert ring may have to be replaced or
removed completely.
Page 50 1902103850