QUNDiS RNN5 Notice D'utilisation page 18

en - Operating and Installation Instructions Q node 5
Operating modes and system states
must be available for this. The respective operating mode is shown on the display:
Operating Display Note
mode
Idle mode This is the mode of the network node
on delivery. It changes to installation
mode after the MODE key has been
Standard This is the normal operating mode of
mode the data collector: Telegrams from
the registered metering devices are
network.
The receiver is continually active and
standard thus makes fast communication pos-
mode sible. This mode is started manually
using the ACT26 service tool.
Installation The wireless network is built up auto-
mode matically in installation mode. Metering
devices which transmit installation tel-
egrams during this operating mode are
registered in the network. This mode
is started by pressing the MODE key
System
Display Note
state
Remote If a network node is accessed by a
access
If all network nodes have their receives
mode
by two dots in the upper section of the
LCD.
Bus
connection
for this bus.
primary address 03 was connected to
the M-Bus.
IrDA-Mas- This mode is started by pressing the
ter mode
ises that other IrDA devices can now be
mode is automatically ended after 10
seconds of inactivity.
Add If a non-registered IrDA-capable meter-
added in the network node. The display
display. The device is then registered
and search mode is started.
18
Operating
mode
installation
mode
installation
mode
Search
mode
search
mode
Delete
mode
System
state
Delete
Copy
-
FUM5-00AM-DES-N5550
Display Note
ters all metering devices which transmit
data telegrams. This mode helps if the
is not built up.
tion is only built up to devices which are
using the same network coding.
Metering devices which have been
entered manually or lost their wireless
connection are synchronised again.
This mode is activated automatically.
This search run is used to re-establish
wireless connection to lost or manually
entered metering devices. This mode
can also be started manually with
and by pressing the MODE key some-
what longer.
tered devices which transmit instal-
Display Note
If a IrDA-capable metering device that
has already been registered is con-
be removed from the network node.
pears on the display. The device is then
deleted and the search mode ended if
appropriate.
Copying the network data of a node
is possible if the new node is in idle
mode.
nodes with open housings in front of
main in front of each other during the
entire copying process.
pending on the data content. When
automatically in search mode. After
network node changes to the standard
mode and must be added manually to
the network node network.
-
-
-
-
-
-
V1.0 / 31.01.2019