Panasonic CS-PW24JKE Mode D'emploi page 5

TO TURN ON OR OFF THE UNIT
• Please be aware of the OFF indication on the remote
control display to prevent the unit from starting/
stopping improperly.
TO SET TEMPERATURE
• For heat, cool and dry modes, the range of
temperature for selection is 16˚C ~ 30˚C.
• Operating the unit within the recommended
temperature could induce energy saving.
HEAT mode : 20˚C ~ 24˚C.
COOL mode : 26˚C ~ 28˚C.
DRY mode : 1˚C ~ 2˚C lower than room temperature.
TO SELECT OPERATION MODE
AUTO mode - For your convenience
• Unit selects the operation mode according to the
room temperature.
• Once auto mode is selected, the unit will operate at
the standard setting temperature.
Room Operation
temperature mode
23˚C & above Cool
Below 23˚C Dry
Below 20˚C Heat
• To change the standard setting temperature, press
for "HI" or for "LO".
Operation mode HI (+2˚C)
Cool
Dry
Heat
HEAT mode - To enjoy warm air
• Unit takes a while to warm up. The power indicator
blinks during this operation.
COOL mode - To enjoy cool air
DRY mode - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
TO SELECT FAN SPEED (3 OPTIONS)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
TO ADJUST VERTICAL AIRFLOW
DIRECTION (5 OPTIONS)
• Keeps the room ventilated.
• If AUTO is set, the louvers swing up/down
automatically.
• In heat mode, the air blows horizontally for a while,
then starts to blow downwards.
Standard setting
temperature
25˚C
22˚C
21˚C
LO (-2˚C)
27˚C 23˚C
24˚C 20˚C
23˚C 19˚C
TO SET THE TIMER TO SET THE TIMER
• To turn ON or OFF the unit at a preset time.
Select ON or Set the time.
OFF timer.
• To cancel ON or OFF timer, press
press .
• When ON Timer is set, the unit may start earlier (up
to 30 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the remote
control and repeats daily once set. For clock setting,
please refer to Remote Control Preparation at back
cover.
• If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
resumed) by pressing
OPTIONAL SETTINGS OPTIONAL SETTINGS
Press and hold for approximately 10
seconds to show 12-hour (am/pm) or 24-
hour time indication.
Press to restore the remote control's default
setting.
Not used in normal operations.
Use curtains to screen off sunlight and outdoor heat to
reduce power consumption during cool mode.
Confi rm.
or then
.
5