Samsung POWERbot SR1M70 Série Mode D'emploi page 38

1_VR7000_EN_DJ68-00763K-08_SW.indd 37
Symptom
Samsung Connect App
cannot be installed.
A message of product
registration failure appears.
During product registration,
recharging button is pressed
and held as instructed but
the next step does not
appear.
During product registration,
the wireless router I want to
connect cannot be searched.
During product registration,
the AP password
1111122222 is not input
correctly.
During product registration,
the password of the
connecting wireless router is
not input correctly.
A connection cut between
the Samsung Connect
App and the POWERbot
occurs though the product
registration is completed.
fSamsung Connect App operates on Andorid OS 6.0 or higher, iOS
10 or higher.
fThe supporting OS version for Samsung Connect App may change
later.
fFor rooted smart devices, standard installation and use will not be
guaranteed.
fTry the product registration procedure again by referring to the
pop-up messages.
fPlease refer to the "Setting up the wireless router" in the user
manual.
fPlease refer to the steps for completing the product registration in
the user manual section "Adding a device to the Samsung Connect
APP".
fWhen the product registration fails repeatedly, reset the
POWERbot and Smartphone, run the Samsung Connect App again
and try the product registration.
fThe same Samsung account should be used for the login of App
and product registration.
fAll users should use the Samsung account issued by the same
country.
fPress the recharging button until you hear it beep.
fIf the next step does not appear within several seconds, press the
recharging button one more time.
fCancel the product registration, run the Samsung Connect App
again, and try the product registration again.
fPress and hold the "[Robot Vacuum] Samsung" on the network list
and delete the network to initialize the password.
fCancel the product registration, run the Samsung Connect App
again, and try the product registration again.
fPress and hold the wireless router you want to connect on the
network list, and delete the network to initialize the password.
fRefresh the screen and wait.
fRun the Samsung Connect App again.
fCheck whether there is an internet connection problem. Especially,
a firewall may interrupt standard operation.
ENGLISH-37
Checklist
2017-12-01 오후 5:07:18