Samsung POWERbot SR1M70 Série Mode D'emploi page 35

Information codes
<SR1✴M702✴✴✴, SR1✴M703✴✴✴, SR2✴M70✴✴✴✴ series>
1
The information
code below is
shown with an
error alarm.
Information codes
1_VR7000_EN_DJ68-00763K-08_SW.indd 34
2
Turn off the
emergency switch
and check the below
instructions and
take appropriate
action
The POWERbot is caught, stuck or trapped while
moving around.
fTurn off the emergency switch and move the POWERbot to
another area.
Foreign matter caught in the brush.
fTurn off the emergency switch and remove the foreign matter
from the brush.
Foreign matter caught in the left Driving wheel.
fTurn off the emergency switch and remove the foreign matter
from the Driving wheel.
Foreign matter caught in the right Driving wheel.
fTurn off the emergency switch and remove the foreign matter
from the Driving wheel.
Bumper sensor needs to be checked.
fTurn off the emergency switch and turn it back on.
fWhen information code does not disappear, check if there's any
small foreign matter between the bumper and the main body.
If there is, pull the bumper slightly and remove the foreign
matter.
Foreign matter accumulated on the obstacle sensor.
fTurn off the emergency switch and clean the front and rear
sensor with a soft cloth.
Foreign matter accumulated on the cliff sensor.
fTurn off the emergency switch and clean the cliff sensor with a
soft cloth.
Main PCB needs to be checked.
fTurn off and restart the product. If the same problem occurs
repeatedly, a service check is required.
ENGLISH-34
3
Information code
will disappear
when you turn on
the emergency
switch
Checklist
2017-12-01 오후 5:07:18