BEBE CONFORT AxissFix Mode D'emploi page 64

EN
a safe and easy fixation of the child safety systems
inside the car. Not all cars are equipped with these
anchors although they are standard on more recent
models. Consult the attached list of cars for which
the car seat can be installed correctly (you can also
consult additional updates of this list on the website
www.bebeconfort.com).
• In rear-facing position (61-87 cm), this product
must not be installed to places equipped with a
frontal air bag. You might be able to deactivate it (see
your car manual). In this case, if you can deactivate
the air bag, you can use the car seat on the front seat.
• In forward facing position (76-105 cm), the seat
must be placed on the car rear seat or exceptionally
on the front seat in accordance with the legislation in
force in the country of use (In France: in accordance
with the conditions stipulated in decree n° 91-1321
du 27-12-1991).
If you use the AxissFix on the front seat, it should be
possible to deactivate the airbag of the seat in ques-
tion or move the passenger seat back to a maximum
(Please consult your car manual).
• When installing the seat in the rear-facing position,
the belt of the TOP TETHER can turn one quarter
turn according to the position of the anchorage
point. This does not impair the proper operation of
the product.
• When installing the car seat, it is necessary
to remove the headrest in order to put the
TOP TETHER through correctly.
• Warning: when installing the car seat, spaces
between the base of the car seat and the vehicle
seat are possible depending on the position of the
anchorage points within the vehicle.
• It is essential that the car seat be replaced after an
accident.
66
• The user must always check that any luggage and
other objects likely to cause injury to the occupant
of the car seat in the case of impact are properly
secured.
• The rigid parts and the plastic sections of a child
restraint device should be positioned and installed in
such a way that they cannot, when the vehicle is be-
ing used under normal conditions, become trapped
under a moving seat or in the vehicle door.
• Never modify the construction or the materials of
the car seat and the seat belt without consulting the
manufacturer.
• Do not use the child restraint device without the
cover. Do not replace the seat cover with a cover
other than that recommended by the manufacturer,
because it will have a direct effect on the functioning
of the child restraint.
• This child restraint is effective only if the instruc-
tions for use are respected.
• Always fasten the child restraint even when the
child is not sitting in it.
• Never place heavy objects on the rear parcel shelf,
to avoid the danger of projectiles in the event of an
accident.
• Always check that no part of the seat or the harness
is trapped under a seat or in the vehicle door.
• Folding seats must always be locked in place.
• If in any doubt about the correct installation or use
of the system, the user is advised to contact the dis-
tributor or the manufacturer of the child restraining
device system.
CARE
Fabric:
• The cover and the shoulder pads can be removed
for washing. If the cover needs to be replaced at any