Defi Nitions: Safety Guidelines; Ec Declaration Of Conformity; General Power Tool Safety Warnings - DeWalt DCD710 Mode D'emploi

Fuses
Europe 230 V tools
U.K. & Ireland 230 V tools
Defi nitions: Safety Guidelines
The definitions below describe the level of severity
for each signal word. Please read the manual and
pay attention to these symbols.
DANGER: Indicates an imminently
hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING: Indicates a potentially
hazardous situation which, if not
avoided, could result in death or
serious injury.
CAUTION: Indicates a potentially
hazardous situation which, if not
avoided, may result in minor or
moderate injury.
NOTICE: Indicates a practice not
related to personal injury which, if
not avoided, may result in property
damage.
Denotes risk of electric shock.
Denotes risk of fire.
EC-Declaration of Conformity
MACHINERY DIRECTIVE
10.8 V CORDLESS ADJUSTABLE CLUTCH DRILL/DRIVER
DCD710
D WALT declares that these products described
E
under Technical Data are in compliance with:
2006/42/EC, EN60745-1:2009+A11:2010,
EN60745-2-1:2010.
These products also comply with Directive
2004/108/EC (until 19.04.2016), 2014/30/EU (from
20.04.2016) and 2011/65/EU. For more information,
please contact D WALT at the following address or
E
refer to the back of the manual.
The undersigned is responsible for compilation of
the technical file and makes this declaration on
behalf of D WALT.
E
Markus Rompel
Director Engineering
10 Amperes, mains
D WALT, Richard-Klinger-Straße 11,
E
D-65510, Idstein, Germany
3 Amperes, in plugs
14.04.2015

General Power Tool Safety Warnings

SAVE ALL WARNINGS AND INSTRUCTIONS
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.
1) WORK AREA SAFETY
a)
b)
c)
2) ELECTRICAL SAFETY
a)
b)
c)
d)
e)
WARNING: To reduce the risk of injury,
read the instruction manual.
WARNING! Read all safety warnings
and all instructions. Failure to follow
the warnings and instructions may result
in electric shock, fire and/or serious
injury.
FOR FUTURE REFERENCE
Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power
tools create sparks which may ignite the dust
or fumes.
Keep children and bystanders away while
operating a power tool. Distractions can
cause you to lose control.
Power tool plugs must match the outlet.
Never modify the plug in any way. Do
not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs
and matching outlets will reduce risk of
electric shock.
Avoid body contact with earthed or
grounded surfaces such as pipes,
radiators, ranges and refrigerators. There
is an increased risk of electric shock if your
body is earthed or grounded.
Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
Do not abuse the cord. Never use the
cord for carrying, pulling or unplugging
the power tool. Keep cord away from
heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the
risk of electric shock.
When operating a power tool outdoors,
use an extension cord suitable for outdoor
use. Use of a cord suitable for outdoor use
reduces the risk of electric shock.
ENGLISH
29