Wheels; Dust Bag; Lubrication; Service And Spare Parts - Bona Edge UX Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 46
Routine Maintenance (Cont.)

Wheels

Remove dirt from the machine unit and wheels regularly. Dirt may cause uneven sanding.

Dust bag

Remove the bag and shake it well, using a mask and safety goggles, to remove sawdust. It is recommended to properly
dispose of the sawdust. Turn the bag inside out and wash it in the machine in cold water to prevent blockage of the pores
and a decrease in dust collection ability.

Lubrication

The machine does not require lubrication. All moving parts, including the motor, have watertight ball bearings lubricated for
approximately 10,000 hours of operation.

Service and Spare Parts

Service

Bona Edge UX is a high quality machine and is tested by authorized test staff at the factory before delivery. However, electrical
and mechanical parts wear down and age during long-term use.
Only Bona's original parts may be used because the machine is considered unique, otherwise safety functions can become
impaired.
When you contact Bona or staff approved by Bona in the event of a fault or to order spare parts, always specify the type and
serial number of your machine. This information is located on the data plate of the machine.

Spare parts and exploded views

On the Internet, you will find a list of spare parts and exploded views for Bona Edge and other machines in our product range.
Visit http://spareparts.bona.com/
During the factory warranty period, repairs may only be carried by Bona or staff approved by Bona. Other repairs (after the
warranty period) of mechanical or electrical parts on the machine may only be carried out by Bona or staff approved by Bona
who has experience and knowledge concerning safety regulations.
20
Bona Edge UX

Publicité

Table des Matières
loading

Table des Matières