Starting Machine Description; Machine Use; Working Method; Starting The Machine - Bona Edge UX Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 46

Starting Machine Description

Machine use

The machine is intended for the edge sanding of wooden floors. It may be used on newly laid and untreated floors and existing
floors that have been treated with lacquer or oil.
The main function of the machine is to serve as a complement to a belt or a drum sander for sanding edges.
The machine has been thoroughly checked and approved before leaving the factory.

Working method

When sanding, hold the machine, use both handles and move the machine in circles in the direction of rotation over the surface
which is to be sanded. It is important that the machine rests on three points, both the wheels and the sanding disc.
The best result is obtained by letting the machine work with its own weight.
When using fine abrasives you must be careful not to make any burn marks due to high friction created.
In addition to the points noted the sanding must be adapted to the type, pattern and composition of the floor.

Starting the machine

1.
Become familiar with
the machine and read all
instructions and safety
notices. Ensure that all
operators read this manual.
3.
Fit the disc in accordance
with the 'Abrasive Assembly
Procedures' (pg.14).
12
2.
Use a remote control industrial vacuum cleaner intended for wooden dust (maximum length
of pipe: 10 m - pipe diameter: 38 mm). As an alternative, fix the bag by tying the cord over the
suction elbow flange.
4.
Locate the power supply. The socket must be compatible
with the plug. To avoid electrical hazards the socket must be
grounded with a 16 A fuse. Connect the plug to the socket.
Bona Edge UX

Publicité

Table des Matières
loading

Table des Matières