Adjusting The Working Surface On The Floor; Wall Protection; Routine Maintenance - Bona Edge UX Mode D'emploi

Machine Adjustment Procedures (Cont.)

Adjusting the working surface on the floor

1.
The tilt of working plate is determined by the position of the
wheels on their support. This support slides on a guide and can
be set at the needed position by a locking knob.

Wall protection

1.
Follow the 'Replacing
the cogged belt'
(pag.16) up to point 3.

Routine Maintenance

To keep the machine in good working condition the following
items must be checked and serviced regularly (every 250
working hours or at least once a year).
2.
For moving upward/downward the machine loosen the lower
knob. Turn clockwise/counter-clockwise the screw using the
upper knob. Screw again the lower knob to lock the wheel
position.
2.
The wall protection is replaceable in easy
way by unscrewing the two fixing screws
from the two slots, that allow to adjust in
opportune way its distance from the wall.
All maintenance must be done on neutral machine!
Always disconnected the machine from power supply before
it is cleaned, tools are changed, maintenance is performed or
when worn parts are replaced.
EN
Bona Edge UX
15